Completing The Move; Levelling; Fitting The Stability Bracket Or Chain - Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.

Completing the move

Unfold the rear edge of the cardboard base tray. Open the
oven door(s) so that you can get a good grip on the bottom
of the fascia panel as you move the oven (Fig. 9.6).
Carefully push the range backwards off the base tray. Remove
the base tray.
Position the range close to its final position, leaving just
enough space to get behind it (Fig. 9.7).
DO NOT use the door handles or control knobs to
n n
manoeuvre the range.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range turn the
adjusting nuts at the front bottom corners of the range. To set
the front feet turn the bases to raise or lower.
Fitting the stability bracket or
chain
Unless otherwise stated, a range using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 9.8 and Fig. 9.9.
If you are using a stability chain (Fig. 9.8) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the range.
If you are using a stability bracket (Fig. 9.9), first attach the
bracket location device to the rear of the range (Fig. 9.9).
Then adjust the bracket to engage through the slot of the
device (Fig. 9.10 and Fig. 9.11).
Repositioning the range following
connection
If you need to move the range once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the range slightly
(Fig. 9.6), you need to check behind the range to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the range to
move.
With a stability chain fitted, release it as you ease the range
out. DO NOT forget to refit it when you replace the range.
When you replace the range, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
INSTALLATION
Alternative positions
for stability location
bracket
Stability bracket
Wall
27
ArtNo.010-0004 Moving the cooker
Stability chain
Cooker
Stability
location
bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Stability
bracket
Cooker
Stability
location
bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical wall mounting
Fig. 9.6
Fig. 9.7
Fig. 9.8
Fig. 9.9
Fig. 9.10
Floor
Fig. 9.11
Floor