Table of Contents
Advertisement
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
12. Servicing
Fig. 12.1
Grub Screw
Fig. 12.2
B
0
0
0
ArtNo.255-0015 - 110DF - Elise removing the control panel
A
Grub Screw
0
0
0
0
0
0
A
BEFORE SERVICING ANY GAS CARRYING
n
n
COMPONENTS TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion
n
n
of service. When checking for gas leaks do not use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
Do not use reconditioned or unauthorised gas
n
n
controls.
Disconnect from the electricity supply before
n
n
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
Before electrical reconnection, check that the
n
n
appliance is electrically safe.
B
1 Panels
1.1 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
n
n
Pull off all the control knobs. Remove the handrail (Fig. 12.1).
A
Using a 2 mm Allen key, undo the 2 retaining screws in the
base and side of each handrail support and remove.
Remove the 3 fixing screws (A) from the underside of the
control panel (Fig. 12.2). Remove the 2 screws (B) that were
hidden by the handrail supports. Lift the control panel clear,
taking care not to damage or strain the wiring.
Disconnect the wiring from the rear. Re assemble in the
reverse order when replacing the leads refer to the wiring
diagram
1.2 To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY
n
n
Remove the control panel (see 1.1). Pull the cooker forward.
Remove the 4 retaining screws for each panel (1 at the front
base, 1 on the top and 2 at the rear).
Reassemble in the reverse order.
34
SUPPLY.
Hide quick links:
Advertisement
Table of Contents
