11. Conversion To Lp Gas; Conversion From Natural Gas (1.0 Kpa); Hotplate - Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

11. Conversion to LP Gas

Conversion from Natural Gas
(1.0 kPa) to LPG X Propane
(2.54 kPa)
A suitably competent person must perform the
n n
conversion. After conversion the installation must
comply with the relevant regulations and also the
local electricity supply company requirements. Read
the instructions before converting this appliance.
Failure to convert the appliance correctly could
n n
invalidate any warranty or liability claims and lead
to prosecution.
When servicing or replacing gas-carrying
n n
components disconnect from the gas supply before
starting operation. Check the appliance is gas sound
after completion.
DO NOT use reconditioned or unauthorised gas
n n
controls.
Disconnect from the electricity and gas supply
n n
before conversion.
Before electrical reconnection, check that the
n n
appliance is electrically safe.

Hotplate

Injectors
Remove the burner caps and heads. Remove the old jets
(Fig. 11.1). Fit the new jets (see the 'Technical Data' section
at the back of this book for the correct jets). Reassemble in
reverse order.
Bypass Screw Adjustment
Removing the Control Panel
Pull off all the control knobs. Remove the handrail (Fig. 11.2).
Using a 2 mm Allen key, undo the 2 retaining screws in the
base and side of each handrail support and remove.
Remove the 3 fixing screws (A) from the underside of the
control panel (Fig. 11.3). Remove the 2 screws (B) that were
hidden by the handrail supports. Lift the control panel clear,
taking care not to damage or strain the wiring.
Bypass Screw Adjustment
Turn the bypass screw on each control clockwise to the stop
(Fig. 11.4).
Refit the control panel. Locate the holes in the top edge on
the tags on the inner panel and replace the fixing screws in
the bottom edge.
A
ArtNo.311-0010 Injectors
A – Jet, B – Internal injector, C – External injector
Grub Screw
B
0 0
0
ArtNo.255-0015 - 110DF - Elise removing the control panel
A
ArtNo.0102-0011 - Screwing
the control valve bypass screw
32
B
C
Grub Screw
0 0 0
0 0 0
A
Fig. 11.1
Fig. 11.2
Fig. 11.3
B
A
Fig. 11.4