Fitting The Stability Bracket Or Chain - Falcon 900S Dual Fuel User's Manual & Installation Instructions

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fitting the stability bracket or
Fig. 7.5
Stability bracket
chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Cooker
Suitable stability devices are shown in Fig. 7.4, Fig. 7.5 and
Fig. 7.6.
If you are using a stability chain (Fig. 7.4) then the chain
3 mm min
should be kept as short as is practicable and fixed firmly to
Floor
ArtNo.070-0014 - Stability bracket - Wall fitting
the rear of the cooker.
If you are using a stability bracket (Fig. 7.5 and Fig. 7.6), then
Typical oor mounting
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fig. 7.6
Outer stability
Fit the bracket so that it engages as far as possible over the
bracket
chassis of the cooker.
Repositioning the cooker following
Cooker
connection
If you need to move the cooker once it has been connected
3 mm min
then you need to unplug it and, having gripped under the
Wall
Floor
fascia panel and lifted the front of the cooker slightly
(Fig. 7.3), you need to check behind the cooker to make sure
that the gas hose is not caught.
Typical wall mounting
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker
out. DO NOT forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
23