Fitting The Stability Bracket And Chain; Fitting The Restraining Chain - Falcon Professional + Kitchener 110 User Manual

Installation instructions
Table of Contents

Advertisement

Check the appliance is electrically safe and gas sound when you have nished.

Fitting the Stability Bracket and Chain

A stability bracket and chain MUST be tted when
n
n
the cooker is connected to a exible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT: The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Fitting a Stability Bracket
When tting a stability bracket please refer to the instructions
supplied with the bracket for further details on tting.
When tting a stability bracket (Fig.7-6 and Fig.7-7) adjust
the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.

Fitting the Restraining Chain

The restraining chain MUST be tted.
The length of chain between the appliance and the wall xing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Measure the length of chain required. Use the clamp supplied
to clamp onto the gas pipe (Fig.7-8). Fix the supplied hook
securely to the wall.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
INSTALLATION
Stability bracket
Outer stability
Wall
Restraining
chain
27
Cooker
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
bracket
Cooker
3 mm min
Typical wall mounting
ArtNo.011-0007 - Restraining chain (AUS)
Fig.7-6
Floor
Fig.7-7
Floor
Fig.7-8

Advertisement

Table of Contents
loading

Table of Contents