Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions page 41

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
it clear.
Remove the 2 screws 'A' and allow the plate to drop down
(Fig. 12.9). Remove the 2 screws 'B' , lower the upper plate and
remove through the slot in the cooker back (Fig. 12.10).
Undo the terminal connections, noting their positions.
Remove the element fixings and withdraw the element.
Replace the element and re-assemble parts in reverse order.
Top Element
Open the left-hand oven door and undo the fixings that
secure the heat shield. Remove the top element bracket
fixings and withdraw element. Replace the element and re-
assemble parts in reverse order.
Check the oven operation.
6 Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.2). Remove the plinth
(4 screws) and the central vertical cover (5 screws). Remove
the 2 countersunk screws (1 each side) securing the grill
hinge arms to the front of the grill chamber.
Note: The arms are spring tensioned. Carefully remove the
grill door. Retain the gaskets.
Reassemble in reverse order, making sure that the gasket
is fitted between the hinge arm and the front of the grill
chamber.
6.2 To Replace an Oven Door
Open the oven door. Support the door and loosen the 2
screws securing the upper hinge and gasket to the cooker
front (Fig. 12.11).
The door is heavy, so take care.
n n
Support the door and remove the screw nearest the hinge
pin (Fig. 12.12). Swing the hinge up and away from the
door hinge pin. Lift the door away from the lower hinge and
remove. Reassemble in reverse order.
6.3 To Adjust an Left Hand Oven Door Angle
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 12.13). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 12.14).
Retighten the hinge screws.
6.4 To Replace the Left Hand Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the oven door slightly and remove the 4 front panel
fixing screws from the door sides (2 each side), (Fig. 12.15).
Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing the 2
retaining nuts. Fit the door handle to the new panel. Fit the
panel to the door. Reassemble in the reverse order.
Fig. 12.11
1
ArtNo.320-0001 Door hinges
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
ArtNo.320-0006 Oven door hinge adjustment 1
39
2
ArtNo.320-0001 Door hinges
Centreline of hinge pin
Fig. 12.12
Fig. 12.13
Fig. 12.14
Fig. 12.15