Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions page 37

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
2 Hotplate
2.1 To remove the hotplate
BEFORE SERVICING ANY GAS CARRYING
n n
COMPONENTS, TURN OFF THE GAS SUPPLY.
DISCONNECT FROM THE ELECTRICAL SUPPLY !
n n
Remove the pan supports and burner heads.
Remove the screws holding the hotplate burners to the
hotplate Fig. 12.3
Remove the 5 screws holding the hotplate tray to the cooker
Fig. 12.4
Pull the range forward to gain access to the
Remove the 4 screws holding the flue trim at back of cooker
Fig. 12.5
Taking care not to damage the burner electrodes, carefully lift
the hotplate.
From underneath, disconnect the earth lead at the right –
hand rear from the cross member and withdraw the hotplate.
Reassemble in the reverse order ensuring that the leads are
reconnected. Take care not to damage the ignition electrode
of the wok burner.
2.2 To Replace the Hotplate Control Taps
DISCONNECT FROM THE ELECTRICITY SUPPLY.
n n
BEFORE SERVICING ANY GAS CARRYING
n n
COMPONENTS, TURN OFF THE GAS
Remove the control panel and hotplate (see 1.1 & 2.1).
Unplug the FSD lead from the rear of the tap. Undo the
compression fitting at the rear of the tap and remove the
fixings that secure the tap to the gas rail. Disconnect the
ignition switch wiring.
Remove the tap. Remove and discard the gasket seal. Fit
the new gasket seal to the replacement tap. Reassemble in
reverse order. Check that the appliance is gas sound. Verify
the hotplate ignition.
2.3 To Change a Hotplate Burner Injector
Remove the burner cap and head. Remove the old injector.
Fit the new injector. Reassemble in the reverse order. Check
the appliance is gas sound.
2.4 To Replace a Hotplate Burner Electrode
DISCONNECT FROM THE ELECTRICITY
n n
Lift off pan supports and remove the burner cap. Remove the
screw holding the electrode. Pull the electrode vertically up
sufficiently to grip the lead between thumb and forefinger.
Pull off the electrode, but keep hold of the lead. Fit the new
electrode to the lead. Fix the electrode in the burner with
screw. Replace the burner cap.
Check the burner ignition. Replace the pan supports.
rear.
SUPPLY.
SUPPLY.
35
Screws
Screws
Fig. 12.3
Fig. 12.4
Fig. 12.5