Table of Contents
Advertisement
7.8 Install an ILite stacker profile
All ILite stacker feet has to be installed simultaneous with the ILite rental feet and beams. See chapter "Install
the ILite rental feet with stacker foot", page 41. This procedure describes how to install an ILite stacker profile
upon a stacker foot after 4 rows of ILite rental tiles are built. The same procedure can be used to install a
stacker profile upon the previous installed stacker profile after completing row 7 and row 10.
W
ARNING
feet of the stacker system has to be installed simultaneous with the rental feet and beams.
Necessary tools
13 mm open ended spanner.
Necessary parts
•
Stacker profile.
•
6 stacker mushrooms.
•
1 stacker locking key.
•
2 spring cotters.
How to install an ILite stacker profile ?
1. Insert a stacker mushroom into the bottom corner, of the rental tiles, at the adjoining vertical edge of two rental feet. Use a 13
mm open ended spanner to fasten the stacker mushrooms.
Note: 6 stacker mushrooms are required per stacker profile. The first row of rental tiles does not require a stacker mushroom.
Image 7-28
2. Place the stacker profile simultaneous into the stacker foot and over the stacker mushrooms.
R5976189 ILITE RENTAL DISPLAY 16/09/2005
:
A floor mounted ILite rental display higher then six (6) tiles requires a stacker system. The stacker
7. Basic setup procedures
x 2
x 2
x 2
55
Advertisement
Table of Contents
