Table of Contents
Advertisement
7. Basic setup procedures
Image 7-18
4. Place the next rental tile against the previous placed rental tile as follows:
a) Align the front of the rental tile with the front of the installed tile(s) while approaching the desired location.
b) Place the left bottom side of the rental tile, seen from the rear, upon the rental foot below by tilting the tile a little bit to the left.
The positioning pin of the rental foot below should fit into the left positioning hole of the tile to place.
c) Lower down the other side of the tile with a turning movement. This way, the side position pin, of the tile to place, will easily
fits into the side position hole of the previous installed tile at the right. This is of importance from the second tile on in the row.
Image 7-19
5. Fasten the rental tile with the rental foot below as described in step 2 and 3.
6. Repeat step 4 and 5 until the first row of rental tiles are placed and secured upon the rental feet.
7. Close all row levers of all rental feet.
Note: While closing all row levers, the slightly tilt of the tiles described in step 2 will disappear.
50
R5976189 ILITE RENTAL DISPLAY 16/09/2005
Advertisement
Table of Contents
