Set Up A Hanging Ilite Rental Display - Barco ILite Installation Manual

6. Setup process of an ILite rental display

6.2 Set up a hanging ILite rental display

W
ARNING
with the local regulations regarding such installations and that the truss installation will be able to support
the complete load of the ILite rental display.
W
ARNING
Setup process
1. The first stage in the process is the installation of the truss beams upon ILite rental tiles. See detailed procedure "Install the ILite
truss beam upon ILite rental tiles", page 57.
Image 6-4
2. The second stage in the process is joining the truss beams together. See detailed procedure "Join two ILite truss beams together",
page 60.
Image 6-5
3. The next stage is the installation of the remaining ILite rental tiles row by row. See procedure "Install a row of ILite rental tiles
into a hanging configuration", page 62.
Warning: The maximum height of a hanging ILite rental display is 15 tiles high.
Tip: Realize the power and data cabling simultaneous with the rows of ILite rental tiles. See chapter "Cabling of an ILite
display", page 67.
Image 6-6
4. The next stage is the power and data cabling, if not done in the previous stage, of the ILite rental display. See procedure "Cabling
of an ILite display", page 67.
Warning: To protect against risk of fire by overloading of power cables, the amount of ILite rental tiles per power source cable
is limited. Never connect more than 6 ILite rental tiles with a power source cable.
5. After all ILite rows are built, the LED-wall has to be secured with the truss installation. See chapter "Secure a hanging ILite rental
display", page 65.
6. Installation of the digitizer(s) and, if used, the fiberlink and/or AEC. Follow the installation guidelines in the manuals of these
products.
34
:
Be sure that the truss installation, on which you want to hang the ILite rental display, complies
:
The maximum height of a hanging ILite rental display is 15 tiles high.
R5976189 ILITE RENTAL DISPLAY 16/09/2005