Table of Contents
Advertisement
7. Basic setup procedures
7.7 Install a row of ILite rental tiles into a base stand configuration
This procedure describes how to install a row of ILite rental tiles in order to build a flour mounted ILite display.
The ILite rental feet and the first row of ILite tiles has to be installed upon the rental feet before starting with
this procedure.
Image 7-21
How to install a row of rental tiles into a base stand configuration ?
1. Ensure that all latches (A), safety clamps (B) and row levers (C) of the rental tiles in the previous installed row, on which you want
to build the next row, are in open position.
Image 7-22
2. Ensure that the side latch hook (image 7-22 ref D) of the tile you want to place, is completely turned open.
Tip:
Turn the handle (D), which operates the side latch hook, as much as possible counterclockwise to obtain the open position
of the hook.
3. Place a rental tile upon the previous installed row, start at the right side of the LED-display seen from the rear, as follows:
a) Align the front of the rental tile with the front of the installed tiles while approaching the desired location.
b) Place the left bottom side of the rental tile, seen from the rear, upon the tile below by tilting the tile a little bit to the left. The
left positioning pin of the tile below should fit into the left positioning hole of the tile to place. See image 7-23.
c) Lower down the other side of the tile with a turning movement. This way, the side position pin, of the tile to place, will easily
fits into the side position hole of the previous installed tile at the right. This is of importance from the second tile on in the row.
Caution:
Do not release the tile yet. Hold until the rental tile is secured with safety clamps and latches.
52
A
B
C
D
R5976189 ILITE RENTAL DISPLAY 16/09/2005
Advertisement
Table of Contents
