7. SLITE SERVICING PROCEDURES
7.1 Remove the resync-unit of an SLite tile
Necessary tools
Nut driver 10 mm
How to remove the re-sync unit of an SLite tile ?
1. Unplug the external power and data cables connected with the re-sync unit.
2. Remove the four bolts of the re-sync unit, using a 10 mm nut driver.
3. Gently pull the re-sync unit about 25 cm out of the tile.
Image 7-1
4. Disconnect the power and data cable between the SLite tile and the re-sync unit.
A
Image 7-2
A
Power cable.
B
Data cable.
7.2 Install the re-sync unit
C
AUTION
humidity level inside a sealed tile will damage the internal fans and other electronic parts. Place, if necessary,
some small bags with a liquid absorbing substance (silica gel) inside the tile to absorb the remaining humidity.
R5976621 SLITE DISPLAY 02/09/2005
B
:
Ensure to perform this procedure in a dry and clean environment with a low humidity level. A high
7. SLite servicing procedures
29