Table of Contents
Advertisement
5. Repeat stage 3 and 4 until all rows of the ILite display are installed.
Warning: The maximum height of a base stand ILite rental display is 12 tiles high.
Note: The previous installed stacker profiles will act as stacker feet for the next stacker profiles.
Image 6-3
6. The next stage is the power and data cabling of the ILite rental display. See chapter "Cabling of an ILite display", page 67.
Warning: To protect against risk of fire by overloading of power cables, the amount of ILite rental tiles per power source cable
is limited. Never connect more than 6 ILite rental tiles with a power source cable.
7. Installation of the digitizer(s) and, if used, the fiberlink and/or AEC. Follow the installation guidelines in the manuals of these
products.
8. Installation of the control software for the ILite rental display. See installation procedure described in the manual of the control
software.
9. Energize the ILite rental display and start up the control software. For more information about showing content on the ILite display
see manual of the control software.
W
ARNING
R5976189 ILITE RENTAL DISPLAY 16/09/2005
4
:
The maximum height of a base stand ILite rental display is 12 tiles high.
6. Setup process of an ILite rental display
7
33
Advertisement
Table of Contents
