Table of Contents
Advertisement
10. Servicing
Image 10-6
Tip:
If possible, you can handle over the tile to someone who is standing at the front of the LED-wall.
6. Insert another tile into the LED-wall, from the rear, with next movements:
a) Pull the tile gently diagonally through the opening.
b) Raise the tile vertically and pull it back into position by guiding the positioning pins of the tile through the corresponding
positioning holes of the rental frame.
c) Keep holding the tile firmly, by one of the handles, until the tile is fastened with the rental frame.
Note: Ensure that the new tile contains four black positioning pins.
Caution:
Be careful not to damage the mask, of the LED modules at the front of the tile, while inserting the tile.
Tip:
If possible, someone who is standing at the front of the LED-wall can handle over the tile to you.
Image 10-7
7. Place a nut (Q) on each fixation pin of the tile as illustrated. Do not fasten the nuts yet. Leave roughly 1 mm space between nut
and rental structure, so that the tile can float a little bit within the rental structure.
Image 10-8
84
Q (x4)
R5976189 ILITE RENTAL DISPLAY 16/09/2005
Q
Advertisement
Table of Contents
