Table of Contents
Advertisement
10. Servicing
Image 10-4
Tip:
If possible, you can handle over the tile to someone who is standing at the front of the LED-wall.
6. Insert another tile into the LED-wall, from the rear, with next movements:
a) Pull the tile gently diagonally through the opening.
b) Raise the tile vertically and pull it back into position by guiding the positioning pins of the tile through the corresponding
positioning holes of the rental frame.
c) Keep holding the tile firmly, by one of the handles, until the tile is fastened with the rental frame.
Caution:
Be careful not to damage the mask, of the LED modules at the front of the tile, while inserting the tile.
Tip:
If possible, someone who is standing at the front of the LED-wall can handle over the tile to you.
7. Fasten the ILite tile with the rental frame. Use two nuts at the rear top and two bolts at the rear bottom. See image 10-3.
8. Did you perform a "hot swap" in step 3 ?
If yes, reinstall the re-sync unit.
If no, reconnect the data cables with the data ports of the re-sync unit.
9. Plug the power cable into the power socket of the ILite tile.
82
R5976189 ILITE RENTAL DISPLAY 16/09/2005
Advertisement
Table of Contents
