Positioning & Aligning Case / Adjusting Levelers / Frame Support Rails - Structural Concepts HARMONY HMO2653R Installation And Operating Manual

POSITIONING & ALIGNING CASE / ADJUSTING LEVELERS / FRAME SUPPORT RAILS
1. Position & Align Case Alongside Other
Cases
 Before adjusting levelers, make certain that the
case is in proper position and, if required,
aligned with adjoining case.
 This may require the repositioning of the case
you are installing or the already positioned case.
2. Adjust Levelers

See illustrations and photos at right.
 Note: Depending upon options and features
chosen, illustrations may not exactly reflect your
particular case's features.
 After case is in proper position, adjust case so it
is level and plumb (see illustrations at right).

You may need to remove front and/or rear
Toe-Kick to access levelers.
 Use adjustable wrench to adjust leveler.
 Depending upon case weight, it may be
necessary to use a Pry Bar to raise the case.
 Do not use Pry Bar on Toe-Kick as it may buck-
le.
 Do not use Pry Bar on End Panel; it may chip.
 Use Pry Bar ONLY on Base Frame to avoid
damaging case.
3. Frame Support Rails Must Be Shimmed
 Illustration below shows frame support rails.
 Shims will be provided with all cases that have
frame support rails.
 Use shims to level case.
 Note: After case is in position, it must be
sealed to floor to prevent entry or leakage of
liquid or moisture.
Adjustable
Wrench
Pry Bar
Frame Support Rails
14
Leveler
Base
Block
Frame
Base
Frame
Toe-Kick
Leveler