Volumetric Dose Programming; Hot Water Delivery; Steam Delivery - La Spaziale S1 Vivaldi Owner's Manual

3.6 Volumetric Dose Programming

The programmable volumetric dosing feature allows programming of the single shot
(24) and double shot (25) buttons to dispense whatever quantities of espresso the user
desires. Their use for single shot and double shot quantities is merely a suggestion.
Many users only pull double shots and program the double shot button for 1.5-2.0oz for
that purpose. Then they program the "single shot" button for a larger amount for use in
flushing the portafilter basket and/or the group between shots. The beauty of the
programmable dosing feature is that the machine owner can be creative. The following
are the instructions for programming each button assuming they are being used for
single and double shots.
1. With the machine on, press the ON//OFF (27) button and keep it pressed for about
3 seconds; the control light (22) and the one indicating the set temperature start
flashing.
2. Insert the 1 cup basket into the portafilter handle (11) and fill it with 7-8g of ground
coffee making sure not to leave coffee powder on the upper edge of the portafilter
handle, and press it with the included plastic tamper or, more optimally, a high
quality 53mm coffee tamper.
3. Fasten the portafilter handle (11) to the brewing group (l0), placing a cup under the
portafilter handle.
4. By pressing the one cup button (24) the delivery starts and the lights 14-15-16 turn
on to show that the one shot espresso dose is being programmed.
5. When the coffee inside the cup has reached the desired quantity, again press the
button (24) to stop the delivery.
6. You automatically return to the initial visualization.
7. Repeat the previous steps above using the 2 cup button (25) making sure you
change the filter inside the portafilter handle (11) to the double shot basket and fill it
with 14-16g of espresso first.

3.7 Hot Water Delivery

(only possible with the boiler turned on, light 13 on)
1. Place the pitcher below the hot water output (28):
2. Press the hot water delivery push-button (23).
3. The hot water delivery starts (at this stage the pump is working).
4. Once the desired quantity is reached, stop the delivery by pressing the same button
(23)

3.8 Steam Delivery

(only possible with the boiler turned on, light 13 turned on)
1. Insert the steam wand (2) in the pitcher containing the drink to be heated.
2. Turn the steam knob (6) counter-clockwise, regulating the steam flow according to
the need.
S1 Owner's Manual
Page 7