Observe Power Grid Information; Triggering Function - ITech IT8300 Series User Manual

P-Protect
Time
On
Remote-Sense
Off
On
Ext-Program
Off

3.8 Observe power grid information

The regenerative power value can be observed on the front panel of IT8300
series, including voltage, frequency and power of each phase, as well as total
power, total current regenerative and total historical regenerative power.
1. Press [Shift]+ [CR] (AC-Meter) to enter the power grid information
interface.
"Display" and "Clear" are displayed on the interface.
Select "Display", then the current regenerative power value will display.
2.
L1:234.8Vac
3. Press down arrow key to display the regenerative power value of L2 and L3,
total power, total current regenerative and total historical regenerative
power.
P=0.00kw
E=125.1kwh
E_total=215.7kwh
You can zero the total current regenerative power value by selecting "Clear",
but the total historical regenerative power value can't be cleared.

3.9 Triggering function

Triggering function is necessary to operate dynamic pulse output and list output.
There are three triggering methods to trigger the tested instrument. Optional
triggering sources of triggering function of electronic load comprise:

Manual trigger: when key trigger is valid, press [Shift] + .(Trigger) key and
Delay= 3S
Off
Point=100W
Delay= 3S
On
Delay=10S
Off
49.95Hz 0.0kw
total power
total current regenerative power
total historical regenerative power
Copyright © ITECH Electronics Co., Ltd.
Set software current protective
delay.
Stop function.
Set software power protection.
Set software power protective
value.
Set software power protective
delay.
Set LOAD ON timer.
Start function.
Set LOAD ON timer value.
Stop function.
Start remote
compensation function
Stop remote
compensation function
Start external 0-10 V analog
quantity control function.
Stop external 0-10 V analog
quantity control function.
Function and Features
sense
sense
14