Safety Precautions; Environmental Conditions - ITech IT8300 Series User Manual

Safety Precautions

General safety precautions below must be followed in each phase of instrument
operation. In case of failure to follow these precautions or specific warnings in
other parts of the manual, violation against the safety standards related to the
design, manufacture and purpose of the instrument will occur. If the user does
not follow these precautions, ITECH will bear no responsibility arising there
from.

Do not use the instrument if it is damaged. Before operation, check
the casing to see whether it cracks. Do not operate the instrument in
the presence of inflammable gasses, vapors or dusts.

The electronic load is provided with a power cable during delivery
and should be connected to a junction box. Before operation, be sure
that the electronic load is well grounded.

Use electric wires of appropriate load. All loading wires should be
capable of bearing maximum short-circuit of electronic load without
overheating.

Check all marks on the instrument before connecting the instrument
to electronic load.

Ensure the voltage fluctuation of mains supply is less than 10% of the
working voltage range in order to reduce risks of fire and electric
shock.

Do not install alternative parts on the instrument or perform any
unauthorized modification.

Do not use the equipment when the removable cover is dismantled or
loose.

Please use the power adapter supplied by the manufacturer to avoid
accidental injury.

We do not accept responsibility for any direct or indirect financial
damage or loss of profit that might occur when using the instrument.

This instrument is used for industrial purposes, do not apply this
product to IT power supply system.

Do not use the equipment on the life support system or other
equipment with safety requirements.

If the equipment is not used in the manner specified by the
manufacturer, its protection may be damaged.

Always use dry cloth to clean the equipment housing. Do not clean
the inside of the instrument.

Do not block the air vent of the equipment.

Environmental conditions

The instrument can only be used indoors or in low condensation areas. The
following table shows general environmental requirements for this instrument.
Copyright © ITECH Electronics Co., Ltd.
IT8300 User Manual
ii