Removing A 2.5-Inch Drive From The 3.5-Inch Drive Adapter - Dell EMC PowerEdge T340 Installation And Service Manual

CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported.
Steps
1 Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2 Align the screw holes on the drive with the screws holes on the drive carrier. When aligned correctly, the back of the drive is flush with
the back of the drive carrier.
3 Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-pounds.
NOTE: Use the screws shipped with the drive carrier to secure the drive to the drive carrier.
Figure 33. Installing a drive into the drive carrier
Next steps
1 Replace the drive carrier.
2 Install the front bezel.
3 Follow the procedure listed in

Removing a 2.5-inch drive from the 3.5-inch drive adapter

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove 3.5-inch drive adapter from the 3.5-inch drive carrier.
NOTE: A 2.5 inch hot swappable drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch hot swappable
drive carrier.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2 Remove the drive from the 3.5-inch drive adapter.
60 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.