Important Safety Instructions - MUTOH Viper TX Operation Instructions Manual

1.4 IMPORTANT SAFETY INSTRUCTIONS

General safety instructions that must be observed to use the equipment safely are explained below.
Do not place the printer in the following areas. Doing so may result in the printer tipping or falling over
and causing injury.
Unstable surfaces
o
Sloping floor.
o
Areas subject to vibration by other equipment
o
Do not stand on or place heavy objects on your printer. Doing so may result in the printer tipping or
falling over and causing injury.
Do not cover the ventilation hole of your printer with cloth, such as a blanket or table cloth. Doing so
could obstruct ventilation and cause fire.
Do not place the printer in humid and dusty areas. Doing so may result in electrical shock or fire.
Do not use a damaged power cable. Doing so may result in electrical shock.
Do not attempt to plug in electrical plugs with wet hands. Doing so may result in electrical shock.
Do not connect earth cables in the following areas.
Gas pipes → Doing so may cause fire or an explosion.
o
Earth terminals for telephone line or lightning rod → Doing so may cause a large flow of voltage if
o
lightning occurs.
Water pipes or faucets → If there is a plastic part in the pipe, the earth will not work properly.
o
Do not insert or drop metal or inflammable objects into openings, such as ventilation outlets. Doing so
may result in electrical shock and fire.
Stop using your printer if a liquid is spilled into it. This may cause electrical shock or fire. Turn the
printer off as soon as possible, unplug the power cord, contact your local MUTOH dealer.
Be sure to use the attached cable. Otherwise, electrical shock or fire may occur.
Be sure to use the specified voltage (AC 100 V to 120V, or AC 220V to 240V). Otherwise, electrical
shock or fire may occur.
Use electricity directly from a power outlet (AC 100 V to 120V, or AC 220V to 240V). Do not put many
loads on one electrical output. Otherwise, heat may be generated and cause fire.
Be sure to use an outlet with an earth terminal and use the terminal correctly. Otherwise, electrical
shock or fire may occur.
Follow the instructions below when handling the power cable.
Do not modify the cable.
o
Do not put heavy objects on the cable.
o
Do not bend, twist or pull the cable.
o
Do not wire the cable near equipment that generates heat.
o
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
o
Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
Be careful not to pinch your fingers when opening and closing the front cover.
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
Do not touch the roll feed, this can result in decreased print quality.
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
Downloaded From ManualsPrinter.com Manuals
Viper TX – Operation Instructions
10
AP-75710, Rev. 1.1, 09/01/2008