Param. Settings Page - Huawei RMS-SNMP01A User Manual

RMS-SNMP01A SNMP Card
User Manual

4.4.3 Param. Settings Page

In the UPS information area, choose Param. Settings > Alarm Settings, you can set the high
and low temperature and humidity alarm thresholds, as shown in
text box, the value range is displayed. Enter a value within the range.
default values and value ranges.
Figure 4-12 Parameter settings (alarm settings)
Table 4-3 Default parameter values and value ranges
Parameter
Overtemperature threshold
Undertemperature threshold
Overhumidity threshold
Underhumidity threshold
If a CIM is configured, in the UPS information area, choose Param. Settings > Battery
String Settings, and you can set the battery strings connected to each UPS, as shown in
Figure



Issue 08 (2020-01-09)
The Param. Settings is active only the SNMP card is equipped with a temperature and humidity sensor.
4-13.
Number of battery strings: The information about the battery strings connected to the
UPS. A maximum of four battery strings can be added for each UPS.
Number of batteries in a battery string: The number of batteries in each battery string.
Batteries String No.: The No. of battery string connected to the UPS. The No. cannot be
greater than the number of battery strings set on this page.
Copyright © Huawei Technologies Co., Ltd.
Default Value
40° C
0° C
90% RH
10% RH
4 Managing the UPS on the WebUI
Figure 4-12. If you click a
Table 4-3 lists the
Value Range
30–60° C
–30º C to +10° C
70–100% RH
0–40% RH
32