Huawei RMS-SNMP01A User Manual page 48

RMS-SNMP01A SNMP Card
User Manual
Figure 4-21 Comm. Config page
Configuring a Sender's Email Settings
Under the Sender's Email Settings, set Email server IP address, Sender's email, SMTP
port, and Use secure connection (TLS encryption). Choose if User account authentication
required when sending a mail, if you select Yes, set the User Name and Password. Then
click Submit. When an alarm is generated, the alarm information will be sent to the receivers'
mailboxes. You can delete the sender's email configurations, after click Delet.
Configuring Alarm Notification Settings
On the Alarm Notification Settings page, you can choose whether to enable email and SMS
notifications (requiring a GSM modem), Timely Reminder, and select alarm severities
(critical, major, minor, or All), as shown in
receiver number can be configured on the User Mgmt. tab.
If you enable alarm notification by email or SMS, when there is an alarm, the system will
send emails or short messages to the receiver at 8:00, 12:00, 16:00, and 20:00. If the SNMP
card is powered on within one hour after 8:00, 12:00, 16:00, or 20:00, the system will check
whether the alarm notification has been sent at the previous hour after power-on. If the
notification has not been sent, the system will send it. If the notification has been sent, the
system will not send again. If the SNMP card is powered on more than one hour after 8:00,
12:00, 16:00, or 20:00, the alarm notification will not be sent, and it will be sent at the next
specified hour.
Issue 08 (2020-01-09) Copyright © Huawei Technologies Co., Ltd.
4 Managing the UPS on the WebUI
Figure 4-21. The user name and SMS notification
40