Oil Level Check - Mahindra Genio DC BS-IV Maintenance Manual

Maintenance Manual
GENIO DC
(BS-III & BS-IV)
705-MAT-0002: 0.05 hrs.
ENGINE OIL – LEVEL & LEAK – CHECK
A
DIPSTICK
C
Oil Level Check – Refer illustrations shown.
1. Pull out the dip stick gauge and wipe it clean with a cloth/paper.
2. Insert the dip stick gauge into the dip stick guide fully till the end.
3. Pull out the dip stick slowly and check for the oil level between Maximum and
Minimum level - if found below, top up with recommended oil.
4. Start the engine and check for oil leakage/ seepage at –
Refer illustration [C] checkpoints are shown with arrows.
Oil sump & crankcase joint.

Oil sump drain plug.

Oil filter joint.

 Ensure that the vehicle is parked on level ground/2 post lift/4 post lift.
If the activity is done on a 2 post lift, ensure that the LSPV spring is disconnected

before lifting the vehicle. After lowering, re-connect the LSPV spring and ensure
that the setting height is correct.
Ensure that the engine is not running when oil level check is being done.

If the engine was running before, wait for 10-12 minutes to accumulate oil in the

sump and then do oil level check.
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2011 Mahindra & Mahindra Ltd.
B
DIPSTICK
MAX
MIN
135
MAN-00
JULY 2011
/Rev1
DIPSTICK
GUIDE
4