Good Workshop Practices - Mahindra Genio DC BS-IV Maintenance Manual

Good Workshop Practices

Attire/Dress
 Always wear clean uniform
 Wear safety shoes
 Wear gloves, when required
Wear belt cover

Vehicle Protection
Put seat cover, fender cover, steering wheel cover, before starting the operations.

Safety
 When working with 2 or more persons, be sure to check safety for one another
 When working with engine running, make sure to provide ventilation for exhaust fumes in the
workshop
 If working on high temperature, high pressure, rotating, moving, or vibrating parts, wear
appropriate safety gear and take extra care not to injure yourself or others.
When jacking up the vehicle, be sure to support the specified location with a safety stand.

When lifting up the vehicle, use appropriate safety equipment.

Parts and tools
 Before starting operation, prepare tool stand, MST, Gauges, oils and parts for replacement.
Removed Parts
Place removed parts in a separate box to avoid mixing them up with new parts or contaminating

new parts.
For non-reusable parts such as gaskets, O-rings, and self-locking nuts, replace them with new

ones as instructed in the manual
Retain the removed parts for customer inspection, if requested.

IMPORTANT
Mahindra Xylo mEagle is fitted with LSPV (Load Sensing Pressure Regulating Valve) in the
brake circuit. Hence it is imperative that the
the vehicle on a
disturbing the LSPV settings, leading to different braking characteristics.
Ensure to re‐connect the LSPV spring and measure the fitted length after lowering the
vehicle from the 2‐post lift.
© 2011 Mahindra & Mahindra Ltd. All rights reserved. This book may not be reproduced or copied, in whole or in part, without
the written permission of Mahindra & Mahindra Ltd.
2‐post lift. Failure to do so can lead to elongation of the spring,
LSPV spring is disconnected before lifting