Door Setting - For Side - Mahindra Genio DC BS-IV Maintenance Manual

Maintenance Manual
GENIO DC
(BS-III & BS-IV)
705-MAT-0036 : 0.25 hrs
DOOR SETTING
DOOR STRIKER

Door Setting - For Side

Refer photos shown.
1. Open the door and while closing it check whether striker is at the centre of latch. If it is
not at the centre of latch, striker will foul with top or bottom portion of latch. Loosen
the bolts of striker and move the striker up or down to remove the fouling.
2. Check whether door is over flush or under flush. If it is over flush move the striker
towards vehicle centre and check flushness. If it is under flush move the striker away
from vehicle centre and check flushness.
3. After above corrections are done tighten the striker mounting bolts with torque value
25 N-m to 30 N-m
Door setting to be done at first 5000kms.service schedule.
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2011 Mahindra & Mahindra Ltd.
STRICKER MOUNTING SCREW - LOOSEN
doors:
135
MAN-00
JULY 2011
/Rev1
DOOR LATCH
50