Fuel Filter - Replace; Fuel Filter Assembly - Mahindra Genio DC BS-IV Maintenance Manual

Maintenance Manual
GENIO DC
(BS-III & BS-IV)
705-MAT-0011 : 0.30 hrs.
FUEL FILTER – REPLACE

Fuel Filter Assembly

FUEL FILTER – REPLACE
Refer above illustrations shown.
1. Place fuel collecting tray below fuel filter assembly;
2. Rotate water drain socket in anti clock wise direction and drain water from filter
assembly.
3. Rotate the fuel filter assembly in anticlockwise direction by hand and remove; refer
illustration for dismantling of Fuel filter [3]
4. Fit a new fuel filter element and tighten it by hand; refer illustration for assembling of
Fuel filter [4]
5. Remove the fuel tank cap.
6. Switch the Ignition to 'ON' position.
7. Start the Engine.
8. Check for fuel leak/ seepage if any.
Always use genuine fuel filter assembly.

Fuel filter to be replaced at every 20000kms or earlier if found choked.

The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2011 Mahindra & Mahindra Ltd.
Fuel Filter
Element
4
Fuel Filter dismantling & assembly
procedure
135
MAN-00
JULY 2011
/Rev1
3
2
14