Connecting The Device - Pepperl+Fuchs HiC2081 Manual

Temperature Converter HiC2081, HiD2081, HiD2082
Installation and mounting
Mounting the device on the Termination Board:
• Push the Quick Lok bar (1) into the upper position.
• Center the pins (2) above the contact elements of the Termination Board. Note the
connection direction of the device.
• Center the locking pins (3) above the locking elements of the Termination Board.
• Carefully push the device into the contacts and locking elements.
• Push the red Quick Lok bar (1) down on either side of the device.
The device is mounted now.

5. 2 Connecting the device

The device is connected by means of the terminals of the Termination Board, which permits a fast and
faultfree exchange in case of failure.
The terminals are self-opening and have a spacious connecting area for a core cross-section of up to
2.5 mm².
12 - EN
(1) Quick Lok Bar
(2)Pins
(3)Locking pins
1
3
2