Diskette Cable; Removing The Diskette Cable - Sun Microsystems Ultra 1 Series Service Manual

Diskette Cable

Note -
50. If the system does not have a CD-ROM or a tape drive, go directly to Step 4 on
page 51.
1. Remove the two drive mounting screws from the chassis.
See Figure 8–11.
Figure 8–11
2. Remove the DC harness from the clip located on the drive bracket.
See Figure 8–11.
3. Push the drive bracket toward the disk drive bay, and gently flip it over. Place
it on top of the disk drive bay.
Sun Ultra 1 Series Service Manual ♦ Revision A, November 1995
50
If a CD-ROM or tape drive is installed in this system, begin at Step 1 on page
Removing the Drive Bracket