Powering On The System - Sun Microsystems Ultra 1 Series Service Manual

Figure 6–1
Caution -
supply. When servicing any other system components, the AC power cord should
remain connected. When the system power is in the stand-by position, and the AC
power cord remains connected to a power outlet, the hazardous AC voltage is still
present in the power supply primary.
5. Turn off the power to the monitor.
6. Disconnect cables to any external units.

Powering On the System

1. Turn the power switch on to all peripherals connected to the system.
Turn the power on to the attached peripherals first so the system will recognize
the peripherals when the system is powered on.
2. Turn on the power switch to the monitor.
3. Turn on the power switch to the system.
Sun Ultra 1 Series Service Manual ♦ Revision A, November 1995
34
Rear View of the System
You must disconnect the AC power cord prior to handling the power