Devkit Setup; Connections; Booting Devkit Live Usb On Pc - Intel Galileo Tutorial Manual

2 DevKit Setup

Establish the target and host connections as shown it the figure below:
USB <-> 3.5mm Stereo Serial
115200, 8bit, 1Stopbit, No Parity
DevKit Live
USB Image
2.1

Connections:

1. Insert the micro SD card supplied with the DevKit in the SD Card slot of Galileo.
2. Connect Ethernet cable between Galileo board and your internet router.
3. Plug-in serial cable between your Host PC (USB end) and 3.5mm stereo jack male pin in to
Galileo board audio type serial connector close to Ethernet port.
4. Connect power cable to Galileo board and switch ON the power.
2.2

Booting DevKit Live USB on PC:

NOTE: The BIOS configuration are all PC specific, please refer to your PC manufacturer
guide for details on specific BIOS settings.
1. Insert the provided DevKit Live USB key into the USB port of the Host PC.
2. Power on the computer and enter into BIOS menu.
3. Ensure that the legacy BIOS is enabled.
4. Select – USB key as the first boot device in the boot order.
5. Save your settings and exit the BIOS menu, reboot the Host PC.
Intel® Galileo Development Kit for IoT - Tutorial Guide
Intel® Galileo Target
User's Host PC / Mac
Figure 1: DevKit Development System and Target connections
micro SD card
Power
User's
Router
Revision 1.0 – 20-Feb-2014
(Page 7 of 32)