Speed - Safety Vision RouteRecorder 4C SD SS User Manual

RouteRecoRdeR 4c Sd SS uSeR guide
For more information about
connecting the RouteRecorder 4C SD
SS to a vehicle speedometer, please
contact Safety Vision Technical
Support.
ALARM: Select ON to enable the ALM LED on the front of the RouteRecorder 4C
SD SS when the THRESHOLD speed is reached and an event is triggered. This LED
continues to flash after an event is triggered until the configuration menus are
accessed.
LOCK: Select ON to lock the video of the event recorded when the THRESHOLD
speed is reached (not allowing it to be overwritten).

Speed

The Speed menu controls the speed type
(SPDL and SPDO) events.
Use the remote control to configure the
following options:
SPEED SOURCE: Select VEHICLE to
obtain vehicle speed data from the
vehicle's own speedometer, or GPS to
obtain this data from the GPS signal.
SPEED UNIT: Select MPH to use miles per
hour or KPH to use kilometers per hour.
ALARM SETTING: Select the following
options for LOWSPEED and OVERSPEED:
ENABLE: Select ON to enable this SPEED
event. Select OFF to disable it.
THRESHOLD: Use the number keys on
the remote control to enter the speed at
which the event is triggered.