Uploading Socketserver With Portvision Dx - Comtrol DeviceMaster DM-2000 Series Installation And Configuration Manual

Uploading SocketServer with PortVision DX

4. If the version on the web site is later than the version on the DeviceMaster, download the file, and then go
to Uploading SocketServer with PortVision DX
If the SocketServer version on the DeviceMaster is current, you are ready to continue the installation and
configuration process.
Uploading SocketServer with PortVision DX
Use this section to upload a newer version of
Technical Support recommends updating SocketServer before any further configuration to avoid configuration
problems.
You can use this procedure if your DeviceMaster is connected to the host PC, laptop, or if the DeviceMaster
resides on the local network segment.
1. Make sure that you have downloaded the latest SocketServer version from:
http://downloads.comtrol.com/dev_mstr/rts/software/socketserver.
2. If necessary, open PortVision DX: Comtrol > PortVision DX or use the desktop shortcut.
3. Right-click the DeviceMaster or DeviceMasters for which you want to update, click Advanced > Upload
Firmware, browse to the SocketServer .cmtl file, and then click Open.
If the Detection Type is set to REMOTE, you may want to change it to LOCAL. The DeviceMaster Status on
a DeviceMaster that is set to REMOTE displays in blue:
42 - Initial Configuration
on Page 42.
SocketServer on the DeviceMaster using PortVision DX.
Optionally, you can highlight the DeviceMaster and
click the Upload button in the Launch bar.
ON-LINE
DeviceMaster Installation and Configuration Guide: 2000594 Rev. F
(TCP).