Comtrol DeviceMaster DM-2000 Series Installation And Configuration Manual page 138

RedBoot Procedures
sernum [prefix] [serial_number]
sernum [serial_number]†
?
snmp [disable|enable]
summary
telnet [disable | enable}
teltimeout [seconds]
terse
t485 port #1 port #2
timeout {seconds}
version
† Read-only items that you cannot change in Redboot.
138 - RedBoot Procedures
RedBoot Commands (Continued)
Displays device serial number (if available).
Displays short help.
Sets or displays SNMP enable.
Displays a summary that includes the bootloader version, network
address information, MAC address, and security settings.
Sets or displays telnet server enable. Disables telnet.
Shows or sets telnet time-out.
Terse command response mode.
Runs port-to-port RS-485 test. This is not available on the DeviceMaster
Serial Hub. Port numbering is Port 0 through 15 and you must connect a
straight-through cable such as Ethernet patch cord.
Displays or sets Bootloader time-out value.
Displays RedBoot version information.
DeviceMaster Installation and Configuration Guide: 2000594 Rev. F