Advertisement
INTRODUCTION
The RocketLinx ES8509-XT is an industrial Gigabit managed Ethernet switch
with nine Gigabit ports that include:
•
Four 10/100/1000BASE-TX RJ45 ports
•
Five 10/100/1000BASE-TX RJ45 or 100BASE-FX Single-Mode/Multi-Mode
and 1000BASE-X Single-Mode/Multi-Mode SFP transceiver with SFP
Digital Diagnostic Monitoring (DDM)
See the Comtrol web site for detailed product specifications.
INSTALLATION OVERVIEW
You can use the following overview to install the ES8509-XT. If you need
more detailed installation and configuration information, you can refer to
the RocketLinx ES8509-XT User Guide, which is available on the site at http://
downloads.comtrol.com.
Wiring the Power Inputs
The ES8509-XT provides redundant power, reverse polarity protection, and
accepts a positive or negative power source. However, PW1 and PW2 must
apply to the same mode.
1.
Insert the positive and
negative wires into PW+ and
PW- contacts (PW1 and PW2).
You can connect a single
power supply or both power
supplies depending on your
requirements.
If both power inputs are
connected, the ES8509-XT
is powered from the highest
connected voltage.
2.
Tighten the wire-clamp screws
to prevent the wires from
being loosened.
1
Advertisement
