Replacing Hardware - Comtrol DeviceMaster DM-2000 Series Installation And Configuration Manual

Hardware Installation

Replacing Hardware

Use this procedure to replace hardware.
1. Remove the old unit and attach a new or spare DeviceMaster.
2. Connect the new DeviceMaster to the network hub or server NIC.
3. Apply power to the new DeviceMaster and verify that it passes the power on self-test.
4. Program the IP address of the new DeviceMaster.
5. If necessary, upload the latest protocol firmware.
6. Configure any ports as necessary to match the previous unit or upload configuration files from PortVision
DX.
7. Transfer all cabling from the old DeviceMaster to the new DeviceMaster.
8. It is not necessary to shut down and restart the host PC.
DeviceMaster Installation and Configuration Guide: 2000594 Rev. F Hardware Installation - 31