Bosch Rexroth VFC 3210 Operating Instructions Manual page 128

Bosch Rexroth AG
Functions and Parameters
Fig. 12-10: Multi-speed control via digital inputs
Set [E1.15] = 0 or 1 first.
Connect switch K1 to X1, and set [E1.00] = '1: Multi-speed control input 1'.
Connect switch K2 to X2, and set [E1.01] = '2: Multi-speed control input 2'.
Connect switch K3 to X3, and set [E1.02] = '3: Multi-speed control input 3'.
Connect switch K4 to X4, and set [E1.03] = '35: Forward running (FWD)'.
K5 K4 K3
Open
Open
See chapter "2-wire
control mode 1" on
Open
page 123 and chap-
Open
ter "2-wire control
Closed
mode 2 (Forward /
Closed
reverse, run / stop)"
on page 124
Closed
Closed
Tab. 12-3: Multi-speed settings for 8 or less stages
Direction is controlled by parameters, see
rotation direction, acceleration and deceleration time" on page
100/253
K2 K1
Open Open
Open Closed
Closed Open
Closed Closed
Open Open
Open Closed
Closed Open
Closed Closed
Setting frequency
[E0.07] [E0.26] / [E0.27]
[E3.40] [E3.10] / [E3.11]
[E3.41] [E3.12] / [E3.13]
[E3.42] [E3.14] / [E3.15]
[E3.43] [E3.16] / [E3.17]
[E3.44] [E3.18] / [E3.19]
[E3.45] [E3.20] / [E3.21]
[E3.46] [E3.22] / [E3.23]
fig. 12-9 "Bit definition of
DOK-RCON04-VFC3210****-IT01-EN-P
VFC 3210
Acc. / Dec. time
99.