Cisco ONS 15310-MA SDH Procedure Manual page 13

Chapter 1 Install the Cisco ONS 15310-MA SDH
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
This equipment must be grounded. Never defeat the ground conductor or operate equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
Warning Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements under IEC 60950-1 based safety standards. Statement 1033
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Warning
Statement 1022
Use copper conductors only. Statement 1025
Warning
Caution Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. Plug the
wristband cable into either of the ESD jacks, on the far left and right faceplates in the shelf.
Step 1 Verify that the proper fuse panel is installed (20-amp fuse per shelf minimum). If not, install one
according to manufacturer instructions.
Step 2 Complete the
Step 3 Complete the
Complete the
Step 4
page 18-55.
Step 5 Continue with the
Stop. You have completed this procedure.
78-18668-01
"DLP-H250 Connect the Office Ground to the ONS 15310-MA SDH" task on page
"DLP-H251 Connect Office Power to the ONS 15310-MA SDH" task on page
"DLP-H252 Turn On and Verify Office Power to the ONS 15310-MA SDH" task on
"NTP-H152 Install the Fan-Tray Assembly" procedure on page
Required Tools and Equipment
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
18-51.
18-54.
1-14.
1-13