Cisco ONS 15310-MA SDH Procedure Manual page 35

Hide thumbs Also See for ONS 15310-MA SDH:
Table of Contents

Advertisement

Chapter 1
Install the Cisco ONS 15310-MA SDH
Figure 1-9
Installing the Front Door
Line up the four screw holes on the door hinge with the corresponding screw holes on the flange of the
Step 2
shelf assembly. Make sure the other two holes on the hinge line up with the two holes on the ESD
faceplate on the left side of the shelf.
Approaching the shelf assembly from the left side, install four 4-40 screws to attach the door hinge to
Step 3
the chassis flange.
Step 4
Install two 4-40 screws through the hinge into the ESD faceplate.
Attach the door striker to the right side of the chassis using the remaining two 4-40 screws.
Step 5
Slide the front door downward onto the hinge pins.
Step 6
Using the 5/16-inch nut driver, attach the ground cable to the threaded studs on the door and hinge with
Step 7
two hex nuts. Ensure the ground cable is looped or bent downward to avoid being pinched or caught
when the door is closed.
Step 8
Close the front door.
Be careful not to crimp any cables that are connected to the installed cards.
Caution
Stop. You have completed this procedure.
78-18668-01
Screws
Hinge
Ground strap
Door striker
Required Tools and Equipment
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
1-35

Advertisement

Table of Contents
loading

Table of Contents