Cisco ONS 15310-MA SDH Procedure Manual page 15

Chapter 1 Install the Cisco ONS 15310-MA SDH
Figure 1-6
Slide the air filter into the bracket, and push the tab closed
Step 2
Pull the fan tray ejector all the way out.
Step 3
Use the ejector to slide the fan tray into the shelf assembly until the electrical plug at the rear of the tray
Step 4
plugs into the corresponding receptacle on the backplane.
Close the ejector.
Step 5
Use a Phillips screwdriver to tighten the screws at either end of the fan-tray assembly.
Step 6
To verify that the tray has plugged into the backplane, look at the fan tray and listen to determine that
Step 7
the fans are running.
Figure 1-7
78-18668-01
Installing the Fan-Tray Air Filter
shows the location of the fan-tray assembly.
Required Tools and Equipment
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
1-15