Cisco ONS 15310-MA SDH Procedure Manual page 19

Chapter 1 Install the Cisco ONS 15310-MA SDH
NTP-H154 Install the Ethernet Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Warning To comply with the Telcordia GR-1089 Network Equipment Building Systems (NEBS) standard for
electromagnetic compatibility and safety, connect the copper Ethernet ports to intrabuilding or
nonexposed wiring and cabling only.
Warning The Ethernet ports and the LAN port on 15310E-CTX-K9 cards of ONS15310-MA SDH are intra-building
ports and are suitable only for connecting to cat-5 shielded (STP) cabling grounded at both ends.
Statement 1084
Warning The CRAFT ports of ONS15310-MA SDH are intra-building ports used only for setup and maintenance
purposes by trained personnel and are not connected during normal operation. Statement 1085
Do not install an Ethernet card in an ONS 15310-MA SDH if the ambient temperature exceeds 149
Caution
degrees F (65 degrees C).
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. Plug the
Caution
wristband cable into either of the ESD jacks, on the far left and right faceplates in the shelf.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
78-18668-01
This procedure installs the Ethernet cards (CE-100T-8, CE-MR-6, or
ML-100T-8) in the ONS 15310-MA SDH. Ethernet cards can be installed
in any traffic card slot (Slot 1, 2, 5, or 6).
None
DLP-H8 Turn On and Verify DC Office Power on the ONS 15310-MA
SDH, page 16-11
As needed
Onsite
Retrieve or higher
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
Required Tools and Equipment
1-19