Scanning Instructions - Newland NLS-HR42 User Manual

Scanning Instructions

When the scanner is in the default scan mode, you can follow the steps below to scan a barcode:
1. Press and hold the trigger. Then the scanner will project a red hair-cross aiming pattern.
2. Center the aiming pattern on the barcode, as shown in the figure below.
3. Release the trigger when the aiming pattern goes off. If the barcode is decoded successfully, the scanner will emit a
good decode beep and the decoded data will be sent to the host device.
Note: For barcodes of the same batch, the scanner keeps a high success ratio in certain distance which is regarded as the
optimal scanning distance.
11