Scanning Instructions - Newland NLS-HR22 User Manual

Scanning Instructions

When the scanner is in the Manual scan mode, you can follow the steps below to scan a barcode:
1. Press and hold the Trigger. Then the scanner will project a red aiming beam.
2. Aim the red beam across the center of barcode, as shown below.
3. Release the Trigger when the red beam goes off. If the barcode is decoded successfully, the scanner
will emit a good read beep and the decoded data will be sent to the Host.
Note: For barcodes of the same batch, the scanner keeps a very high success ratio in certain distance
which is regarded as the optimal scanning distance.
9
Enter Setup
** Exit Setup