Custom Suffix; Enable/Disable Custom Suffix; Set Custom Suffix - Newland NLS-HR42 User Manual

Custom Suffix

Enable/Disable Custom Suffix

If custom suffix is enabled, you are allowed to append to the data a user-defined suffix that cannot exceed 10 characters.
For example, if the custom suffix is "AB" and the barcode data is "123", the Host will receive "123AB".
@CSUENA0
** Disable Custom Suffix

Set Custom Suffix

To set a custom suffix, scan the Set Custom Suffix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired suffix then the Save barcode.
Note: A custom suffix cannot exceed 10 characters.
Set the custom suffix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
223
Scan the Set Custom Suffix barcode.
Scan the numeric barcodes "4","3","4","F","4","4","4" and "5" from the "Digit Barcodes" section in
Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Enable Custom Suffix barcode.
@CSUSET
Set Custom Suffix
@CSUENA1
Enable Custom Suffix