Advertisement
Step 16. Enter the New Model Number
Procedure Requirements
• The analyzer must be powered up and operating to perform this procedure.
• The Network Analyzer program must be running.
• A keyboard is required for this procedure.
• A mouse is recommended for this procedure but is not required.
Mouse Procedure
1. On the analyzer's System menu, point to Service, then click Option Enable.
2. Click Repair.
3. Check Model shown is incorrect!, then click Begin Repair.
4. In the Model Change box, select the new model number, E8363B.
5. Using the keyboard, enter the keyword in the box provided. The keyword is printed on the
License Key Certificate. Enter this keyword exactly as it is printed on the certificate.
6. Click Enter Model.
7. Verify that the new model number displayed is correct, then click YES. If it is not correct,
click NO and repeat the repair.
8. When the installation is complete, click Exit.
Front Panel Keys Procedure
1. In the COMMAND block, press Menu/Dialog.
2. In the NAVIGATION block, press the right tab and arrow keys to move over to the System
menu and down to the Service selection. Press the right tab to display the extended menu
and the arrows to select Option Enable. Press Click.
3. Press Menu/Dialog, then press R on the keyboard to select Repair.
4. Tab to Model shown is incorrect!, then press Click.
5. Tab to the Model Change box, then use the arrows to select the new model number,
E8363B.
6. Tab to the Keyword box and, using the keyboard, enter the keyword. The keyword is
printed on the License Key Certificate. Enter this keyword exactly as it is printed on the
certificate.
7. Tab to Enter Model, then press Click.
8. Verify that the new model number displayed is correct, then tab to Yes and press Click. If
it is not correct, tab to NO, press Click, and repeat the repair.
9. When the installation is complete, Tab to Exit, then press Click.
28
Installation Note E8362-90004
Advertisement
