Advertisement
Step 14. Reinstall the Front Panel Assembly
Before installing the front panel assembly onto the analyzer, lift and support the
CAUTION
front of the analyzer chassis.
1. Reconnect the ribbon cable (item
2. Slide the front panel over the test port connectors being careful to align the power switch
and floppy disk drive to their corresponding front panel cutouts. Ensure that the ribbon
x
cable (item
) is located below the fan to prevent it from being damaged by the fan blades.
3. Using a T-10 TORX driver, install the eight screws (item
Figure 18
Front Panel Assembly Reinstallation
Installation Note E8362-90004
x
) to the A3 front panel interface board.
y
) in the sides of the frame.
25
Advertisement
