Advertisement
Reinstall the Outer Cover
This procedure is best performed with the analyzer resting on its front
CAUTION
handles in the vertical position. Do not place the analyzer on its front panel
without the handles. This will damage the front panel assemblies.
1. Slide the cover onto the frame.
2. Using a T-20 TORX driver, install the four rear panel feet (item
{
screws (item
).
3. Slide the four bottom feet (item
4. Using a T-20 TORX driver, install the strap handles (item
y
(item
) on both ends.
Figure 20 Outer Cover Reinstallation
Installation Note E8362-90004
|
) onto the cover.
z
) by installing the center
x
) by tightening the screws
27
Advertisement
