Advertisement
Step 6. Raise the Receiver Deck
1. Place the analyzer bottom-side up on a flat surface.
2. Using a T-10 TORX driver, remove the four screws, (item
3. Pull the latch pin (item
deck.
4. Lift the receiver deck to partially raise it, then release the latch pin (item
receiver deck to its fully raised position and ensure that the latch pin latches in the raised
position.
Figure 6
Receiver Deck Raising
Installation Note E8362-90004
y
) towards the opposite side of the analyzer to release the receiver
x
), that secure the receiver deck.
y
). Lift the
13
Advertisement
