RIGOL
Note: When the current measurement source is MATH, only the
parameters in the Zoom region can be measured.
When Zoom is disabled, "Main" is automatically selected in Screen and
cannot be modified.
4. Select X (Y) Axis Unit
When the measurement source is "CH1", "CH2" or "MATH"
When the display mode is "X" or "X-Y", press Time Unit to select "s", "Hz", "°"
s: in the measurement results, A->X, B->X and △X denote time and 1/△X
or "%".
Hz: in the measurement results, A->X, B->X and △X denote frequency and
denotes frequency.
°: in the measurement results, A->X, B->X and △X are expressed in degree.
1/△X denotes time.
At this point, A->X, B->X and △X will change to "0°", "360°" and "360°"
respectively when you press SetCursor, no matter where cursor A and
cursor B are currently located. At the same time, two cursor lines
(unmovable) appear on the screen as the reference positions.
%: in the measurement results, A->X, B->X and △X are expressed in
At this point, A->X, B->X and △X will change to "0%", "100%" and "100%"
percentage.
respectively when you press SetCursor, no matter where cursor A and B
are currently located. At the same time, two cursor lines (unmovable)
appear on the screen as the reference positions.
Note: When the display mode is set to "Y", the Time Unit menu will be hidden
automatically and cannot be set.
When the display mode is "Y" or "X-Y", press Vertical Unit to select "Source
Unit" or "%".
units of A->Y, B->Y and △Y will be automatically set to the unit of the
Source Unit: when this unit is selected, in the measurement results, the
current source.
△X are expressed in percentage. At this point, A->Y, B->Y and △X will
%: when this unit is selected, in the measurement results, A->Y, B->Y and
change to "0%", "100%" and "100%" respectively when you press
SetCursor, no matter where cursor A and B are currently located. At the
same time, two cursor lines (unmovable) appear on the screen as the
6-32
Chapter 6 MATH and Measurements
DS2000E User's Guide