Rigol DS2000E Series User Manual page 275

Chapter 16 Specifications
Byte Length
SPI Trigger
Trigger Condition
Timeout Value
Data Bits
Data Setting
CAN Trigger (Optional)
Signal Type
Trigger Condition
Signal Rate
Sample Points
Frame Type
Error Type
USB Trigger (Optional)
Signal Speed
Trigger Condition
Measure
Cursor
Auto
Measurement
Number of
Measurements
DS2000E User's Guide
1 to 5
Timeout
100 ns to 1 s
4 bits to 32 bits
H, L, X
Rx, Tx, CAN_H, CAN_L, Differential
SOF, EOF, Frame Type, Frame Error
10 kbps, 20 kbps, 33.3 kbps, 50 kbps, 62.5 kbps, 83.3 kbps,
100 kbps, 125 kbps, 250 kbps, 500 kbps, 800 kbps, 1 Mbps,
User
5% to 95%
Data, Remote, Error, OverLoad
Bit Fill, Answer Error, Check Error, Format Error, Random Error
Low Speed, Full Speed
SOP, EOP, RC, Suspend, Exit Suspend
Voltage Deviation between Cursors (△V)
Reciprocal of △T (Hz) (1/△T)
Time Deviation between Cursors (△T)
Manual Mode
Track Mode Voltage and Time Values of the Waveform
Point
Auto Mode Allow to display cursors during auto
measurement
Maximum, Minimum, Peak-Peak Value, Top Value, Bottom
Value, Amplitude, Average, Vrms-N, Vrms-1, Overshoot,
Pre-shoot, Area, Period Area, Frequency, Period, Rise Time,
Fall Time, Positive Pulse Width, Negative Pulse Width, Positive
Duty Cycle, Negative Duty Cycle, Delay A B , Delay
A B , Delay A B , Delay A B , Phase A B ,
Phase A B , Phase A B , Phase A B
Display 5 measurements at the same time
RIGOL
16-5